Use only the bundled power adapter to charge the battery pack and supply power to your LED projector.Location and distance between the projector and other equipment.Personal preference and room layout will decide the installation location. Dispose of used batteries according to the manufacturer’s instructions and local environment regulations for your region.Ĭhoosing a Location - Projector Orientation.If the battery is drained or if you will not be using the remote control for an extended period of time, remove the battery to avoid damage to the remote control.Replace only with the same or equivalent type recommended by the battery manufacturer.Avoid leaving the remote control and batteries in excessive heat or a humid environment.Refit the cover by aligning it with the base and pushing it back down into position.Positive (+) goes to positive and negative (-) goes to negative.
#Miroir micro projector m40 upside down install#
Remove any existing batteries (if necessary) and install two AAA batteries observing the battery polarities as indicated in the base of the battery compartment.To open the battery cover, turn the remote control over to view its back, open the cover in the direction of the arrow.The distance between the remote control and the sensor(s) should not exceed 8 m (26 ft.).The remote control must be held at an angle within 30° perpendicular to the projector’s IR remote control sensor(s).To ensure proper function of the remote control follow the steps below: ↑ Blank the projection image and focus on the music.
NOTE: The apparent brightness of the projected image will vary depending on the ambient lighting conditions, selected input signal contrast/brightness settings, and projection distance.
0 kommentar(er)
